Huijue Core Switch IP Configuration

To configure the IP address on a Huijue core switch, use the CLI to assign a static IP to the management interface, set the gateway, and enable the interface.

Step-by-Step IP Configuration

1. Access the Switch CLI
   • Connect via console cable or SSH to the Huijue core switch.
   • Log in with super administrator privileges to ensure full configuration access .
2. Enter System View
   • Execute the command:

     system-view

   • This switches the CLI into configuration mode where you can modify interfaces and IP settings .
3. Select the Management Interface
   • Identify the management interface (commonly eth0 or a VLAN interface used for management).
   • Enter interface configuration mode:

     interface eth0 or for a VLAN interface:

     interface Vlan 410

4. Assign the IP Address
   • Set a static IPv4 address and subnet mask:

     ip address <IP_ADDRESS> <SUBNET_MASK>

   • Example:

     ip address 192.168.1.10 255.255.255.0

5. Set the Default Gateway
   • Configure the gateway to allow the switch to communicate outside its subnet:

     ip route-static 0.0.0.0 0.0.0.0 <GATEWAY_IP>

   • Example:

     ip route-static 0.0.0.0 0.0.0.0 192.168.1.1

6. Enable the Interface
   • Ensure the management interface is active:

     undo shutdown

7. Verify Configuration
   • Exit to the main CLI and test connectivity:

     ping <GATEWAY_IP>

   • Confirm the IP is correctly assigned:

     display ip interface brief

Additional Tips

• If the switch supports Layer 2/Layer 3 mode, ensure the interface is in Layer 3 mode before assigning the management IP .
• For VLAN-based management, make sure the VLAN is created and active:

  vlan 410quitinterface Vlan 410ip address 192.168.1.10 255.255.255.0undo shutdown

• Always save the configuration to prevent loss after reboot:

  save

By following these steps, the Huijue core switch will have a static management IP, proper gateway configuration, and an active interface ready for network management and monitoring .